Crushing Equipment
Crusher
A crusher is a machine designed to reduce large solid material objects into a smaller volume, or smaller pieces. more
Jaw Crusher
Jaw crusher is mainly used to crush large stones primarily, widely used in such industry as mining, metallurgy, building material, road, railway, chemical industry, etc. more.
Impact Crusher
Impact Crusher is our improved product of crusher. Its biggest advantage is as follows: the product is of cubic shape without crack. more
Stone Crusher
Stone Crusher in China. Here, you can get the particular machines of Stone crusher, Stone crusher working Principle, Stone crusher features and benefits, Each series include maximum, medium and minimum types. more
Hammer Mill
LIMING is a trusted and reliable brand for its high quality and good manufacturing. It specializes in producing Hammer Mill which is widely used in mining, quarry, more
Installation of Spring Cone Crusher
Cone crusher installation
- the installation broken cone, we should firmly in the foreground set up a higher point in a wooden rack with a cone crusher installation.
- remove Tu in the shaft and spherical surface of the reservoir protection, and with the wind-net lubricants and oil groove.
- In a cone axis coated yellow oil, the ball thin layer of oil coated surface.
- Cone crusher at the time of installation to Add gently eccentric shaft in the air, secure in his place so that the spherical bearings Bowl and Bowl to avoid contact with tile damage spherical ring, as shown in Figure 9 by the installation.
Idling test of Spring Cone Crusher
- In the above parts of the installation to be done after the air load test to check the installation is in compliance with requirements, if it is found that improper places, this ease of repair.
- crusher should be checked prior to the commencement of the main connecting the retention situation.
- prior to the commencement of transmission of the moving hand climbing, at least to air eccentric axis rotation 2-3 laps. Jin-ying that a flexible phenomenon, before driving.
- activated prior crusher start pumps, lubrication until the point by lubricants, oil back to see me, before launching crusher.
- Test idling continuous operation shall not be less than two hours.
- crusher idling test must meet the following requirements. A broken cone around himself to the center of rotation for no more than 15 to / min. B bevel gear may be cyclical voice. C lubricating device should meet the following requirements. A) tubing to the pressure should be 0.8-1.5 kgf/cm2 range. B) to the oil temperature not exceeding 50 ℃. C) test at the crusher after all demolition should not be part of a paste friction burns and wear copper phenomenon.
- If the taper to a few broken soon may have an undesirable phenomenon, it should be immediately stopped and inspected dressing, and to check the oil and then re-test.
- If the cyclical bevel gear noise, to check the accuracy of gear installation, and inspection gear space.
Feed the installation of the Department of Spring Cone Crusher
- improper installation of the crusher will have the following effects. A crusher to reduce output. B uneven discharge particle size, bulk and more. Wear Parts C or uneven wear accelerated wear.
- distribution of the feed from the mouth of a high degree of H-crusher on the normal work is important, too high when H ore is not easy to direct the allocation of disk space to the crusher, therefore, must be in accordance with the regulations of the high degree to install it.
- radial plate is meant to protect the feed box is not damaged and ores difficult in the feed box to plug in the installation need to maintain the shape and curved steel plate curved mouth feed from the edge of the size, so as to avoid accumulation Ore.
Liming Heavy Industry(Beijing)

